library IEEE, BASIC;
use IEEE.STD_LOGIC_1164.ALL;
use ieee.std_logic_unsigned.all;
use ieee.std_logic_arith.all;

ENTITY test IS
    PORT (
        clk1M                   : IN std_logic;   -- 1MHz 时钟
        clkBtn                  : IN std_logic;   -- CLK 按钮
        rstBtn                  : IN std_logic;   -- RST 按钮
        led1                    : OUT std_logic;   -- 连接LED1
        led2                    : OUT std_logic;   -- 连接LED2
        led3                    : OUT std_logic);   -- 连接LED3
END test;

ARCHITECTURE t OF test IS


    SIGNAL btnSync                  :  std_logic;   
    SIGNAL btnLast                  :  std_logic;   
    SIGNAL counter                  :  std_logic_vector(21 DOWNTO 0);   
    SIGNAL led1_xhdl1               :  std_logic;   
    SIGNAL led2_xhdl2               :  std_logic;   
    SIGNAL led3_xhdl3               :  std_logic;   

BEGIN
    led1 <= led1_xhdl1;
    led2 <= led2_xhdl2;
    led3 <= led3_xhdl3;

    PROCESS
    BEGIN
        WAIT UNTIL (clk1M'EVENT AND clk1M = '1');
        IF (rstBtn = '1') THEN
            counter <= "0000000000000000000000";    
            led1_xhdl1 <= '0';    
        ELSE
            IF (NOT counter /= "0000000000000000000000") THEN
                counter <= counter + "0000000000000000000001";    
            END IF;
            IF (NOT led1_xhdl1 = '1') THEN
            -- 判断counter计时到2s～4s的某个值时，点亮led1，并重新开始计时
            -- === YOUR CODE HERE ===
				IF (counter = "1011011100011011000000") THEN
					counter <= "0000000000000000000000";    
					led1_xhdl1 <= '1';
				end if;    
            END IF;
        END IF;
    END PROCESS;

    PROCESS
    BEGIN
        WAIT UNTIL (clk1M'EVENT AND clk1M = '1');
        btnLast <= btnSync;    
        btnSync <= clkBtn;    
        IF (rstBtn = '1') THEN
            led2_xhdl2 <= '0';    
            led3_xhdl3 <= '0';    
        ELSE
            IF ((btnSync AND NOT btnLast) = '1') THEN
            -- 检测到CLK按钮按下瞬间，根据题目要求比较counter的值，并设置led2，led3
            -- === YOUR CODE HERE ===
				IF (NOT led1_xhdl1 = '1') then
					led2_xhdl2 <= '1';    
					led3_xhdl3 <= '1';    
				elsif (counter > "0001111010000100100000") then
					led2_xhdl2 <= '0';    
					led3_xhdl3 <= '1';  
				else
					led2_xhdl2 <= '1';    
					led3_xhdl3 <= '0';  
				end if;
            END IF;
        END IF;
    END PROCESS;


END t;